Many users who have installed Netgear WiFi routers in their houses are unable to connect to the network created by the router. Do you know what the reason behind the issue is? It is because the Netgear router is not showing up on the network list? As a result, they face issues while accessing routerlogin.net when connected to the router’s network wirelessly. Just in case you are also facing problems seeing the WiFi network of your router on the network list, you are required to check out the information penned down in this post. Here, you will get to know about the topmost causes due to which the router’s SSID does not appear on the WiFi list.
Why is Netgear Router Not Showing Up on Network List?
Prior to learning the reasons causing the Netgear router’s network name to disappear from the WiFi list, we would like to inform you about the simplest remedy that can help you address the problem. It is because technical glitches have secured the topmost position among the reasons creating the problem in the discussion. The solution to these glitches is rebooting. Thus, before anything else, consider restarting the router as soon as possible. Remember that the time frame between the powering down and up of the Netgear wireless router must range from 25-30 minutes.
Now, see if you are able to see the Netgear router WiFi name on the network list. If not, then you must check out the information given below.
Reason 1: You’re Too Far From the Router
Can you read the words written on a book placed at a distance of 20ft? Of course not! In the same way, the device on which you are trying to access the network of the router won’t be able to encrypt the signals if it is present too far from the router. Therefore, be very sure that you are present within the range of the Netgear router. Get a little closer and refresh the network list. Once done, see to it if the network name appears or not.
Reason 2: Outdated Firmware
If not the distance separating you from the router, the outdated firmware version can be the reason why Netgear router is not showing up on network list. Therefore, you are suggested to upgrade the router’s firmware by accessing its dashboard. But, while doing so, make sure that you are connected to the router through a cable. Apart from this, ensure that you are not uploading the incorrect firmware file on the router’s dashboard.
Reason 3: Signal Interference
Too much WiFi interference can also be the reason why you cannot see the Netgear router’s SSID on the network list. Know that this reason also works in the case of a range extender brought in by Netgear. In that case, you cannot see Netgear_ext on the network list. Therefore, no matter whether you are not able to see the extender’s SSID or that of the router on the network list, get the signal interference removed.
For this, you need to change the location of your Netgear device and ensure that it is not present near any device that emits electromagnetic frequencies. Additionally, be sure that the router is not placed near lustrous objects or objects that contain a large amount of water. Moreover, make sure that the router is not placed in a corner or near a thick concrete wall.
Reason 4: Disabled SSID Broadcast
If even after changing the location of the wireless router, the Netgear router not showing up on network list issue does not appear to get off from your back, then chances are that the SSID broadcast is disabled. So, we advise you to make sure that you have not disabled the router’s SSID broadcast. For this, log in to the WiFi router with the help of a wired connection and enable the SSID broadcast.
Reason 5: Improper Setup Process
Lastly, the improper installation process of the Netgear router can also be the reason due to which you cannot see the network name on the WiFi list. Therefore, you are now left with the single option of resetting the router. Locate and press the Reset button using a sharp object. Once the WiFi router resets, install it again via the Nighthawk app or the web-based management method.
With that, the time to wrap up the post has come. It is expected that you will be able to see the network name of the router on the list and connect to it.
