Considering that thinking about the color red generates the idea of something in danger in mind, it is not a good sign if the LED on your Netgear extender is blinking the same color. It means that there is something seriously wrong with your networking device and if not done something about it, your internet-usage experience might go down the drain within a matter of minutes. Not only this, but you will get stuck with Netgear extender login issues eventually. Taking this into account, we have highlighted some troubleshooting hacks in this article. If you walk through them carefully, nothing will be able to stop you from converting the Netgear extender red light to green.
However, before you make your way to the hacks, become aware of the factors that might have contributed to the issue at hand. They have been highlighted in the following section.
What Caused Netgear Extender to Blink Red?
1. Technical Glitches Existence
If you have been using different networking devices for quite some time, then you might be well acquainted with the damage that technical glitches can cause. Chances are that the color of the LED on your extender is blinking red because of the same reason.
2. Inadequate Power Supply
Another reason why you are forced to experience the Netgear extender red light issue is because your networking device is not getting an adequate as well as uninterrupted power supply from the wall outlet that it is connected to.
3. Unstable Internet Connection
Last, but not least, a weak internet connection can also be the factor pushing you into this mess because of two reasons: your ISP is not working properly or the Ethernet cable connecting the networking devices is damaged.
[Resolved] Netgear Extender Red Light Issue
Considering you have walked through the above-mentioned reasons, the time has come for you to gain an understanding of how to fix the Netgear extender red light issue.
1. Restart the Netgear Extender
In order to get rid of the first reason behind the issue at hand, i.e. technical glitches, you need to restart your Netgear wireless range extender. You can do so by turning off your device, holding on for a couple of seconds, and then, powering it back on. Now, see if the red light issue has been fixed or not. On the off chance, you are still experiencing it, walking through the next hack is recommended.
2. Repair the Electrical Socket
Taking into consideration that an improper power supply is being supplied to your networking device, check the wall socket to which it is connected. In case it is damaged, get it repaired without wasting any more time. In case, you would like to get your hands on a better option in comparison, plug your wireless extender into another but non-damaged wall socket. Hopefully, this will work for you.
3. Check the Internet Connection
Did none of the aforementioned troubleshooting hacks help you to resolve the Netgear extender red light issue? Well then, call up your Internet Service Provider. If he agrees that there is some issue from his end, ask him to resolve it within a couple of hours. But, in case, you are not just the victim but also the culprit, then, make use of a new cable to connect the Netgear wireless extender to the host router.
Nothing Worked?
By any chance, if the hacks given above ended up being useless to you in troubleshooting the issue at hand, then you are left with only one option, i.e. set up your Netgear extender from scratch. You can do so by accessing the default IP address, i.e. 192.168.1.250. If you need details regarding the same, refer to the Netgear user manual.
Conclusion
These were some of the best troubleshooting hacks following which one will be able to resolve the Netgear extender red light issue. We hope that after walking through this article, you will be able to change the status of the LED on your networking device.
While learning how to resolve the issue, if you figured out some other hack through which the same issue can be fixed, do share it with your fellow readers. You can do the honors by making use of the comment section.
